----- Original Message -----
Sent: Friday, May 17, 2002 12:29
PM
Subject: Re: BallotStation 4-3-4
Election Mode ballot retension in Pre-Election Testing Mode
Tab,
If you clear the results on the TS unit,
then are you going to implement the request that Tari asked for:
allowing a pollworker to make voter cards on a unit (in case the Spyrus
or PCC runs out of battery or doesn't work). We need a backup
method to make cards in the precinct. Exiting election mode to
access the "CREATE CARD" function is important, but NOT if you lose the
ballots on the unit. Comments?
----- Original Message -----
Sent: Thursday, May 16, 2002 2:15
PM
Subject: Re: BallotStation 4-3-4
Election Mode ballot retension in Pre-Election Testing Mode
No, this is not the
intended behavior. When reseting the election to pre-election
mode the results are ment to be "cleared".
Tab
----- Original Message -----
Sent: Wednesday, May 15, 2002
5:23 PM
Subject: BallotStation 4-3-4
Election Mode ballot retension in Pre-Election Testing Mode
An election is reset to Pre-Election Testing Mode from
Post-Election Mode. Ballots counted in Election Mode are
displayed in Pre-Election Testing Mode View Ballots window. Is
this intended behavior?
Nel