[Date Prev][Date Next] [Chronological] [Thread] [Top]

Re: BallotStation 4-3-4 Election Mode ballot retension in Pre-Election Testing Mode

We will be implementing a method to allow voter cards to be created WITHOUT ending the election. Therefore this is not an issue.

Tab
 
----- Original Message -----
Sent: Friday, May 17, 2002 12:29 PM
Subject: Re: BallotStation 4-3-4 Election Mode ballot retension in Pre-Election Testing Mode

Tab,
If you clear the results on the TS unit, then are you going to implement the request that Tari asked for: allowing a pollworker to make voter cards on a unit (in case the Spyrus or PCC runs out of battery or doesn't work).  We need a backup method to make cards in the precinct.  Exiting election mode to access the "CREATE CARD" function is important, but NOT if you lose the ballots on the unit.  Comments?
----- Original Message -----
Sent: Thursday, May 16, 2002 2:15 PM
Subject: Re: BallotStation 4-3-4 Election Mode ballot retension in Pre-Election Testing Mode

No, this is not the intended behavior.  When reseting the election to pre-election mode the results are ment to be "cleared".
 
Tab
 
----- Original Message -----
To: Support
Sent: Wednesday, May 15, 2002 5:23 PM
Subject: BallotStation 4-3-4 Election Mode ballot retension in Pre-Election Testing Mode

An election is reset to Pre-Election Testing Mode from Post-Election Mode.  Ballots counted in Election Mode are displayed in Pre-Election Testing Mode View Ballots window.  Is this intended behavior?

 

Nel