----- Original Message -----
Sent: Friday, May 17, 2002 12:29
PM
Subject: Re: BallotStation 4-3-4
Election Mode ballot retension in Pre-Election Testing Mode
Tab,
If you clear the results on the TS unit,
then are you going to implement the request that Tari asked for:
allowing a pollworker to make voter cards on a unit (in case the Spyrus or
PCC runs out of battery or doesn't work). We need a backup method to
make cards in the precinct. Exiting election mode to access the
"CREATE CARD" function is important, but NOT if you lose the ballots on the
unit. Comments?
----- Original Message -----
Sent: Thursday, May 16, 2002 2:15
PM
Subject: Re: BallotStation 4-3-4
Election Mode ballot retension in Pre-Election Testing Mode
No, this is not the intended
behavior. When reseting the election to pre-election mode the
results are ment to be "cleared".
Tab
----- Original Message -----
Sent: Wednesday, May 15, 2002 5:23
PM
Subject: BallotStation 4-3-4
Election Mode ballot retension in Pre-Election Testing Mode
An election is reset to Pre-Election Testing Mode from Post-Election
Mode. Ballots counted in Election Mode are displayed in
Pre-Election Testing Mode View Ballots window. Is this intended
behavior?
Nel