----- Original Message ----- 
      
      
      Sent: Friday, May 17, 2002 12:29 
      PM
      Subject: Re: BallotStation 4-3-4 
      Election Mode ballot retension in Pre-Election Testing Mode
      
      Tab,
      If you clear the results on the TS unit, 
      then are you going to implement the request that Tari asked for: 
      allowing a pollworker to make voter cards on a unit (in case the Spyrus or 
      PCC runs out of battery or doesn't work).  We need a backup method to 
      make cards in the precinct.  Exiting election mode to access the 
      "CREATE CARD" function is important, but NOT if you lose the ballots on 
      the unit.  Comments?
      
        ----- Original Message ----- 
        
        
        Sent: Thursday, May 16, 2002 2:15 
        PM
        Subject: Re: BallotStation 4-3-4 
        Election Mode ballot retension in Pre-Election Testing Mode
        
        No, this is not the intended 
        behavior.  When reseting the election to pre-election mode the 
        results are ment to be "cleared".
         
        Tab
         
        
          ----- Original Message ----- 
          
          
          Sent: Wednesday, May 15, 2002 
          5:23 PM
          Subject: BallotStation 4-3-4 
          Election Mode ballot retension in Pre-Election Testing Mode
          
          
          
An election is reset to Pre-Election Testing Mode from 
          Post-Election Mode.  Ballots counted in Election Mode are 
          displayed in Pre-Election Testing Mode View Ballots window.  Is 
          this intended behavior?
           
          Nel