As the man says, this is only for 4.3.6
or 4.4.x. You should have JoCoKs certify 4.4.1 or higher
-----Original Message-----
From: owner-support@gesn.com
[mailto:owner-support@gesn.com] On Behalf Of Lesley
Thompson
Sent: Friday, May 17,
2002 8:13 PM
To: support@gesn.com
Subject: Re: BallotStation 4-3-4 Election
Mode ballot retension in Pre-Election Testing Mode
How
soon is the implementation? Is this for only certain Ballot Station
versions or all Ballot Station versions?
-----
Original Message -----
Sent: Friday, May 17, 2002 3:52 PML
Subject: Re:
BallotStation 4-3-4 Election Mode ballot retension in Pre-Election Testing Mode
We will
be implementing a method to allow voter cards to be created WITHOUT ending
the election. Therefore this is not an issue.
-----
Original Message -----
Sent: Friday, May 17, 2002
12:29 PM
Subject: Re:
BallotStation 4-3-4 Election Mode ballot retension in Pre-Election Testing Mode
If you clear
the results on the TS unit, then are you going to implement the request
that Tari asked for: allowing a pollworker to make voter cards on a unit (in
case the Spyrus or PCC runs out of battery or doesn't work). We need a
backup method to make cards in the precinct. Exiting election mode to
access the "CREATE CARD" function is important, but NOT if you lose
the ballots on the unit. Comments?
-----
Original Message -----
Sent: Thursday, May 16, 2002
2:15 PM
Subject: Re:
BallotStation 4-3-4 Election Mode ballot retension in Pre-Election Testing Mode
No,
this is not the intended behavior. When reseting the election to
pre-election mode the results are ment to be "cleared".
-----
Original Message -----
Sent: Wednesday, May 15,
2002 5:23 PM
Subject:
BallotStation 4-3-4 Election Mode ballot retension in Pre-Election Testing Mode
An election is reset to
Pre-Election Testing Mode from Post-Election Mode. Ballots counted in
Election Mode are displayed in Pre-Election Testing Mode View Ballots
window. Is this intended behavior?
Nel
|