Linux version 2.2.14 (root@bigkitty) (gcc version egcs-2.91.66 19990314/Linux (egcs-1.1.2 release)) #20 Fri Feb 25 19:44:02 PST 2000
Detected 200462214 Hz processor.
Console: colour dummy device 80x25
Calibrating delay loop... 79.87 BogoMIPS
Memory: 28372k/30720k available (1256k kernel code, 408k reserved, 624k data, 60k init)
Checking if this processor honours the WP bit even in supervisor mode... Ok.
Dentry hash table entries: 4096 (order 3, 32k)
Buffer cache hash table entries: 32768 (order 5, 128k)
Page cache hash table entries: 8192 (order 3, 32k)
VFS: Diskquotas version dquot_6.4.0 initialized
CPU: Centaur C6 stepping 01
Centaur FSR was 0x410200 now 0x410286
Checking 386/387 coupling... OK, FPU using exception 16 error reporting.
Checking 'hlt' instruction... OK.
Checking for popad bug... OK.
POSIX conformance testing by UNIFIX
mtrr: v1.35a (19990819) Richard Gooch (rgooch@atnf.csiro.au)
PCI: PCI BIOS revision 2.10 entry at 0xfad70
PCI: Using configuration type 1
PCI: Probing PCI hardware
Linux NET4.0 for Linux 2.2
Based upon Swansea University Computer Society NET3.039
NET4: Unix domain sockets 1.0 for Linux NET4.0.
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
TCP: Hash tables configured (ehash 32768 bhash 32768)
Initializing RT netlink socket
Starting kswapd v 1.5 
vesafb: framebuffer at 0xdd800000, mapped to 0xc2000000, size 2048k
vesafb: mode is 640x480x16, linelength=1280, pages=1
vesafb: protected mode interface info at c000:6314
vesafb: scrolling: redraw
vesafb: directcolor: size=0:5:6:5, shift=0:11:5:0
Console: switching to colour frame buffer device 80x30
fb0: VESA VGA frame buffer device
Detected PS/2 Mouse Port.
Serial driver version 4.27 with HUB-6 MANY_PORTS MULTIPORT SHARE_IRQ enabled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
ttyS01 at 0x02f8 (irq = 3) is a 16550A
pty: 512 Unix98 ptys configured
Real Time Clock Driver v1.09
RAM disk driver initialized:  16 RAM disks of 4096K size
loop: registered device at major 7
VP_IDE: IDE controller on PCI bus 00 dev 39
VP_IDE: not 100% native mode: will probe irqs later
    ide0: BM-DMA at 0xe000-0xe007, BIOS settings: hda:DMA, hdb:DMA
hd1: C/H/S=0/0/0 from BIOS ignored
hda: CD-ROM CDR-C3G, ATAPI CDROM drive
hdb: QUANTUM LP84A 9808094XX, ATA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
hdb: QUANTUM LP84A 9808094XX, 80MB w/64kB Cache, CHS=965/10/17
hda: ATAPI 4X CD-ROM changer w/3 slots, 256kB Cache
Uniform CDROM driver Revision: 2.56
floppy0: no floppy controllers found
md driver 0.36.6 MAX_MD_DEV=4, MAX_REAL=8
linear personality registered
raid0 personality registered
scsi : 0 hosts.
scsi : detected total.
Partition check:
 hdb: hdb1
VFS: Mounted root (ext2 filesystem) readonly.
Freeing unused kernel memory: 60k freed