[Date Prev][Date Next] [Chronological] [Thread] [Top]

Re: AVTS voting unit to card encoder: STEPS



I think you still must end election even if you have no votes  -touch done reporting  -  then you get the 3 block screen at which time you insert the manager card and reset to preelection -  ok to reset -  done reporting then exit administrator and back to the 9 block screen to create voter cards
confirmed - I just did it in 4.1.11
----- Original Message -----
Sent: Thursday, August 01, 2002 6:57 PM
Subject: AVTS voting unit to card encoder: STEPS

Hello good people, can you help me out with the steps to reset an election?  Thanks.  Lesley
 

HOW TO TURN A LIVE AVTS UNIT INTO A VOTER CARD ENCODER
 
SCENARIO 1:  NO VOTES ON AVTS UNIT, USE ACTIVE ELECTION PCMCIA CARD
A. UNSET UNIT FOR ELECTION and SET FOR CREATING VOTER ACCESS CARDS
1    At the VOTING screen, insert MANAGER CARD
2    Input PASSWORD and press OK button
3    Press DONE REPORTING button                      
     (NOTE: zero report should have already been printed and counter should still be at 0)
4    At the POST ELECTION screen, insert MANAGER CARD again
5    Input PASSWORD and press OK button
6   At the MODE screen, press RESET TO PRE-ELECTION MODE button
7    Press EXIT ADMINISTRATOR button
8    At the ELECTION MANAGEMENT screen, press CREATE VOTER CARDS
9    Begin creating cards
NOTE:  This ACTIVE ELECTION PCMCIA Card will not be accumulated with the other units unless after the polls close you SET FOR ELECTION and then END THE ELECTION and PRINT FINAL REPORT.
B. RESET UNIT FOR ENDING ELECTION and PRINTING FINAL REPORT
1    At the CREATE CARDS screen, press EXIT.
2
3
4
5
6
7
8
9