Night Before |
|
Turn on scanner to
charge battery – leave on overnight |
Test Day |
|
Turn
scanner off |
|
Check that printer has
sufficient paper –
Replace paper roll
with AccuVote off |
|
Turn on Feeder
|
|
Hold down Y & N
buttons while turning AccuVote on
Release when display
comes up
Scanner is now in
Diagnostics Mode |
|
Test Network? –
Y |
|
·
Set Baud rate to 9600?
– N |
|
·
Set Baud rate to
19200? – Y |
|
Logging In
Message |
|
Connecting
Message |
|
·
Echo Connection Test?
– N |
|
·
Test Network –
N |
|
Test LCD Display? –
Y |
|
·
Test Continuous? –
N |
|
Test System Memory? -
Y |
|
·
Test Continuous? –
N |
|
Test Printer?
UNPLUG power from
AccuVote and Feeder, then – Y
(Low Power message
will flash while unplugged – this is OK) |
|
·
Repeat Test – Y (total
of 3 tests) |
|
Check tape for legible
output |
|
Plug power back
in |
|
·
Repeat Test –
N |
|
Test
Main Serial
Port? – N |
|
Test
Auxiliary
Serial
Port? – N |
|
Test Ballot Deflector?
– N |
|
Test Ballot Reader –
Y |
|
·
Test with Auto feeder?
– Y |
|
Insert Diagnostic
Ballot in Reader – run card through four times –
on the 5th
time, hold down Y to get report |
|
·
Turn ballot over &
repeat on other side |
|
(Each report will show
number of ballots read, length = 41,
% of values – look for
100% and 0% on each test) |
|
Turn AccuVote and
Feeder OFF |
|
Check for sufficient
paper – replace if necessary |
|
Replace ribbon if
necessary |
|
Tested by:
|
Date: |
|
|
|