[Date Prev][Date Next]
[Chronological]
[Thread]
[Top]
AVTS door problems, after installed into Poll Booth
- To: "Support Team" <support@gesn.com>
- Subject: AVTS door problems, after installed into Poll Booth
- From: "Jeff Hintz" <jhglobal@earthlink.net>
- Date: Tue, 19 Mar 2002 22:53:39 -0600
- Importance: Normal
I am here in Shelby County, TN which has 200 AVTS
units, along with 200 Poll Booths and the hardware for installation.
The hardware has been attached to the AVTS units, and the AVTS units have been
installed into the Poll Booths. I did some spot checking on the doors, to
see if there is a problem like we have in Johnson County, KS. Out of 10
that I checked, there were 2 that need the hex nut adjusted so the point is not
sticking up. There were 2 others that were kind of difficult to get closed
also. I believe that the problem is when the feet are taken off of the
AVTS units, then the flat metal hardware used for inserting the AVTS units into
the Poll Booth is attached, this then makes the AVTS units bottom almost flush
to the top of the Poll Booth, which gives less clearance for the door to open
and close. With the feet on the AVTS units, there is more play in the
door, so it is easier to open and close. I don't know if it is
possible to install the hardware along with the feet, to be able to have the
clearance that we need, both for the doors and for the workers being able
to get to the PCMCIA slots.
Jeff Hintz
Diebold
Election Systems
405 N. 115th Street
Omaha, NE 68154
(402)
697-7171 office
(402) 697-7166 fax
(402) 871-3346
cell