Nell: aren"t there some changes that have
to be entered to customize ghostview for viewing an 18 in ballot. I don't
remember offhand, but will check. From her note it is a problem of viewing in
Ghostview. Is that how you see it?
Thanks: Don
John, print
18" ballot artwork with Global's approved Linotronic driver
electronically to 11 x 22" stock. Make sure you customize the
form size in Ghostview to at least 11 x 22", this way you will be able
to properly view the entire ballot.
Nel
----- Original Message -----
Sent: Tuesday, September 12, 2000
5:46 PM
Subject: Cobb County Offsets?
Folks,
Please take a look at the following and see
what advice we can give to this account. Thanks,
John
I have "printed" my ballots to disk in preparation
for sending them to Doubleday. When I look at them in
GhostView, the ballot is very far down at the bottom of the
page. I can see all of the text, but I cannot see timing marks,
cut marks, etc. Nor can I see the "card number and sequence
number". This makes me think that the offsets need to be
changed, but I have used the defaults, which I thought should
work. It would be very helpful if someone can tell me the
proper offsets to use for an 18" ballot. (Or if there
is some other problem.) I sure appreciate your help!
|