We will try to respond to your requests as much as possible.
We do try to put the correct time on the units when we know where the units
are being delivered before they are packed. We will try to do
better.
We will leave the plastic coating on the door taping from now on. I
will research other tapes for one more suitable for this application.
We will do our best pushing up the network cables but they are likely to
shift during transport. Unfortunately there is no other area to route the
cable.
Keep us informed of suggested improvements.
Steve R.
----- Original Message -----
Sent: Monday, August 28, 2000 10:58
AM
Subject: City of Barrie, Canada - AVTS
units
Just a couple of
added suggestions for when the AVTS units are sent to a customer. It
would be nice if the Date & Time were set according to where they are
shipped. I had to change all the AVTS units to be Eastern Time and
change the time ahead 1 hour. The Network cords that come out of the
back of the unit should be pushed up and out of the way of the disk
drive. Also, the 2 doors with the rubber tape attached should have the
plastic coating stay attached, so as the doors do not seal shut. I had
to pry open most all the doors with a screwdriver, and then reattach the
rubber strips. There were a couple of machines that had the plastic
coating over the rubber strips still attached, and those doors did not
stick.
Just some ideas
for the future.
Jeff Hintz
Global Election Systems
|