Should this have been reported as a
bug??
One of the touchscreen ballot stations has a
significant "distortion" in the touchscreen calibration.
I've used the calibrate function and it works well on the top portion of the
screen, but does not seem to correct itself (I've tried this routine a dozen
times or so to see if I could figure out a pattern). The lower left
corner has to be hit about 1/2 inch above the mark (measured using the edge
of a voter card to be relatively sure about distance). The upper
portion of the screen is correct in its calibration. This makes it
very difficult to use the PREVIOUS function. Or to find many of the admin
functions in windows. Comments??
|