----- Original Message -----
Sent: Monday, July 02, 2001 10:43
AM
Subject: Add "beep" to booting sequence
on R6 unit
Please add a tone as part of the initial boot
sequence on the AV-TS R6 unit. Currently when the unit is powered up,
the screen is blank for about 12 seconds, and there are no other noises in
the system to indicate that you've actually activated the power switch
correctly.
Criteria:
- The tone ("beep") should occur as soon as the CPU
has begun its boot sequence (i.e., 1 to 2 seconds after reset is
lifted). Hopefully there are lower level software commands that
can activate the speaker without having to fully load Windows CE
first.
- The frequency of the tone can be anywhere in the
audible range of most people (i.e., 1kHz to 8kHz).
- The duration of the tone should be between 1/2
second and 1 second.
- The volume of the tone should be loud enough to
hear it but not necessitate covering your ears. Severely audibly
challenged folks will just have to turn up their hearing aids. The
volume of human speech is adequate (i.e. 70 to 80 dB). I don't know
if you would have that kind of control at a lower level of
programming.
The power switch is being changed to a momentary ON
(logic power control by the PIC chip), so there will be no audible click of
the switch.
Ian