Greetings All...
I have been working with an old El Paso, TX database (English
and Spanish) using Gems 1-15-3 and AVTSIS 3-12-1.
I have found the following problems, testing English
only.
The database I was using had 17 Amendments. ( FOR OR
AGAINST)
Everything was going fine up to Amendment #8. I voted
Amendment #8 and received the instructions to "press number 9 to accept"
or
"press 0 to review", I pressed number 9 and moved on to
Amendment #9. After voting Amendment #9 and each Amendment after
that,
I did not receive the instructions to "accept or to review",
it just moved on to the next Amendment.
At Amendment #13 I pressed 0 to "vote race again", it continue
to repeat the first part of the Amendment. I had to press #9 to move
on.
At which time it jumped to Amendment #14. This only
happen for Amendment #13.
I continue voting until the end of the Ballot, at which time I
had the option to "cast ballot or to review ballot", I choose to review
Ballot.
On Amendment # 1, the instructions I received were correct, it
gave me a chance to review my selections.
On Amendment # 2, the instructions made me vote
the Amendment again, and every other Amendment up to Amendment #
8. After
Amendment # 8, the instructions made vote each Amendment
again, instead of allowing me to review my selections.
After all was completed above I got to the end of the Ballot
and cast my vote by pressing number 9. I had to press
it twice for it to be accepted.
The instructions told me vote had been cast.
The counter should that to be true.
I then attempt to print out some results, by pressing
Reporting, by doing so, I received an "Exception error".
Testing is on going.
Rodney
|